Meter4it Engineering , Sequential / Chase taillights for Ford Mustang

Special thanks to Melvin B. (The Blue 2006, nice rims), Terry (the Yellow 2006 Roush) .

NOTE: If the brakes are applied the brake lights will perform the selected pattern and then all lights will stay on. When brake peddle is released the lights will complete the selected pattern until all are off.

OK, what you see is what you get. Nothing to hide here! You get the Sequence / Chase kit with wiring harness, quality Scotchlok wire connectors, Velcro for mounting box, a power wire with mini fuse holder, fuse, and two light sockets. Only thing you need to supply is the hand tools. All wire, wire connectors, and fuse is in the kit.

Now you know what it does and what the kit looks like, now this is how you select the different patterns on the Sequential / Chase unit.

Below is a close-up picture showing the "Calibrate button" and the "Jumper" that is used to control the unit. The Red button is used to calibrate the Sequential / Chase unit to your flashers flasher rate. No potentiometers to adjust here! The Blue Jumper with thumb grip is used to select the desired pattern "Sequential", "Chase", or "Factory"

Key Benefits

	Only one on the market with " Chase " pattern. Three selections via jumper; Sequence , Chase , and Factory ! All in one unit!
	Strong durable plastic housing with mounting flange. Velcro included in kit to secure kit.
	Only one on the market with one button calibration; As you know every flasher flashes at a different rate. Push one button allow blinkers to cycle three times per side and your done. No potentiometers to adjust!
	All wires have different colors . Along with instruction printed in color.
	You have the reliability of modern electronics!
	Fail safe; if unit fails to operate you still have both inboard lights. These two lights are never modified and always operate like they did from the factory.
	Safety; other drivers will notice that something different and point.
	Easy installation, comes with all connectors or you can solder. Soldering is best but, we also supply quality Scotchlok taps that work really good). Although easy is a relative term, you must have basic auto wiring skills.
	I'm using 18GA-GXL automotive wire rated for the engine compartment. That's -51 degrees C to +125 degrees C.
	The wire loom is expandable sleeving in Ford blue. This make for a professional looking install.
	The relays are 15 amp rating. Only 15% of the relay is being used under normal operation giving then longer life.
	Like to rearrange your room? Well I don't, but I do like to make changes to my car. With this one you don't have to pay more to get another option. All you have to do is change a jumper and your done.
	Two year warranty! Just like every one else if unit fails due to no fault of operator I will repair or replace unit minus shipping.
	Kit include two new light sockets, this is because Ford change to a non-serviceable type and you don't have access like in previous once used. For more information on this please look at my FAQ page.